PDA

View Full Version : Guess the Part!!!


farnhamstj
10-18-2009, 10:48 AM
And tell me what the problem is.

thefatkid
10-18-2009, 11:02 AM
Is it a brake caliper slide? It rusted/seized in the caliper? Missing the rubber boot or end plug allowing water in?

farnhamstj
10-18-2009, 11:08 AM
Winner,winner, chicken dinner. rubber boot is still there but slipped off the flange.

thefatkid
10-18-2009, 11:15 AM
What is that off of? It doesn't look like Land Cruiser.

Edit: I'd stab a guess at a Camry, Avalon

TIMZTOY
10-18-2009, 05:04 PM
Car. None of the trucks use those. Unless it's a ford or chevy caliper.
I'm going to go. Rear disk conversion on a Toyota, using chevy Malibu calipers.

farnhamstj
10-18-2009, 08:42 PM
Uhhh, could it be a 1998 Toyota LandCruiser UZJ100 rear caliper.
thefatkid your chicken dinner has been revoked. TIMTOYS don't you work on these things?

pic from FSM BR-23

TIMZTOY
10-19-2009, 12:39 AM
Not any more I don't. And in key west all cars are 2005 or newer because of huricane Wilma. And ther mostly tacomas and prius so none of them really needed rear brakes. don't really go through brakes at all only driving 30mph in a 4x2 mile island. And the first land cruisers I've ever seen in person was Denver. ;)
nice blow up pic :thumb:

Rzeppa
10-20-2009, 07:49 PM
Why would someone put a hex head on something with no threads?:confused:

powderpig
10-20-2009, 08:32 PM
Me guess is the threads are stripped, bummer

thefatkid
10-20-2009, 08:36 PM
The end of that brake pin has a threaded hole in it. You install a bolt through the caliper and thread it in there. The hex is to keep it from spinning while tightening the bolt.