PDA

View Full Version : Toyota Front Diamond Axle Complete W/New Housing


swainbuilt
06-04-2010, 12:03 PM
Complete Toyota Front Axle With all the upgrades

Brand New Diamond Axle Housing built to 64" Wheel mount to Wheel mount ( With current Brake setup it measures 67")
8" High Pinion Electric Locker Third Member
E-Locker Actuator with Marlin Crawler Skid Plate and Control Harness (uses any On/Off switch)
Two Sets of Chromoly Custom Length Inner Axles - 30 Spline
Longfield Chromoly Birfield Joints - 30 Spline
Knuckles Machined By Marlin Crawler for 9/16 Dana 60 Steering Studs
Marlin Crawler Billet Steering Arms and Lower Caps with 25mm Trunion Bearing Pins
Big Brake Kit with Front Range Off Road Caliper Brackets, Drilled and Slotted Rotors and 3rd Gen 4-runner Calipers ( Slip Over Rotor Style for Easy Spindle Access )
Toyota Drive Flanges With ARP Studs
Slick Rock Steering/Rock Stomper 2.25" Double Ended Ram With Tie rods and Heilm/Rod Ends
New Marlin Crawler Seal/Gasket Kit With New 25mm Bearings

The Diamond housing is new and includes knuckle ball gussets, steering stops, spring perches and inner axle seals. Most other parts were new last season.

$3000 or Best Offer

Feel free to call with any questions.

Ben - 303-638-2104
________
Cannabis News (http://potwire.com)

Uncle Ben
06-04-2010, 01:14 PM
Tempting....if it wasn't for that mini truck junk in the center I would throw down...... hmmmmmm

swainbuilt
06-04-2010, 01:23 PM
Officially it's a Land Cruiser diff! The same one as the front of YOUR 7500lb 80 series :D
________
HEMP (http://marijuanahemp.com)

Uncle Ben
06-04-2010, 01:33 PM
Officially it's a Land Cruiser diff! The same one as the front of YOUR 7500lb 80 series :D

Fine if you never back up! :rolleyes::p: For those who don't know me well I al just giving Ben grief. This is a smokin' deal and someone is going to be very happy when they nab it.

AxleIke
06-04-2010, 03:49 PM
Arg! Wish I could. Bump for a good deal!

swainbuilt
06-07-2010, 08:54 AM
For those who don't know me well I al just giving Ben grief.

I would expect nothing less! :D
________
FORD SI6 ENGINE PICTURE (http://www.ford-wiki.com/wiki/Ford_SI6_engine)