PDA

View Full Version : Throttle linkage question.


Drunken Ira Hayes
07-06-2010, 03:33 PM
Hello all,

I'm in the process of putting my 60 series back together and thought that the bracket on the firewall was broken where the ball and pivot for the (throttle) linkage snaps in. I went to the boneyard only to find that said piece on their 60 looked the same as mine. I'm referring to the female portion of the hinged bracket that bolts to the firewall and accepts the male throttle rod that goes to the carburetor. Mine is higher on one side of the female portion and is flush on the other side, consequently the male "ball" doesn't snap in tightly. This is rather difficult without pictures, but if anyone has an idea as to what I'm talking about and would be so kind as to look at this piece on their 60 to see what theirs looks like, it would be appreciated.

Thanks again,

Brad

Drunken Ira Hayes
07-06-2010, 09:57 PM
Figured it out, a small hair clip goes on the high side. Hopefully I'll have this thing ready for the Rally, it's been off the road for about 10 months!

Thanks as always,

Brad