PDA

View Full Version : Source for long splines? (driveshaft)


Red_Chili
05-12-2006, 03:38 PM
8" ain't cuttin' it. Need more, mooooore, MOOOOOOOOORRRRRREEEEE BWAAAAAHHHAAAAAAHHAAAAAAA!!!!!!!!!

Oh, phew. Kinda lost it there for a minute.

I almost separated my front driveshaft a few weeks ago, it's very, very close, and the driveshaft is as long as I dare make it. So I need more spline, d00d.

Anybody got a source for same? Yes, I know Englewood (who does very good work) and Rocky Mountain will redo my dshaft, I am looking for inexpensive and tough ag splines for purchase and DIY install.

Uncle Ben
05-12-2006, 03:58 PM
8" ain't cuttin' it. Need more, mooooore, MOOOOOOOOORRRRRREEEEE BWAAAAAHHHAAAAAAHHAAAAAAA!!!!!!!!!

Oh, phew. Kinda lost it there for a minute.

I almost separated my front driveshaft a few weeks ago, it's very, very close, and the driveshaft is as long as I dare make it. So I need more spline, d00d.

Anybody got a source for same? Yes, I know Englewood (who does very good work) and Rocky Mountain will redo my dshaft, I am looking for inexpensive and tough ag splines for purchase and DIY install.


In my opinion there is only ONE source for long spline never worry about it again DS's. Tom Woods! Your friend in the shaft bussiness!

Seldom Seen
05-13-2006, 01:17 AM
Weld the IFS back on and be done with it :Q

ScaldedDog
05-13-2006, 11:56 PM
In my opinion there is only ONE source for long spline never worry about it again DS's. Tom Woods! Your friend in the shaft bussiness!

Hey Bill. Tom Wood's kid has a shop in Moab: Moab Powertrain, 435-259-5132. He may be able to help you out. BTW, he's the guy that welded my steering box brace on last year, for dirt cheap.

Mark