PDA

View Full Version : Anyone got a solid lifter handy?


frontrange
11-12-2010, 10:29 AM
I just need a measurement of the approximate length on a F/2F lifter. TIA

Rzeppa
11-13-2010, 03:19 PM
I just measured one out of a 1972 F engine with calipers and got 2.265" I'm pretty sure F and 2F use the same lifters.

HTH!

frontrange
11-13-2010, 06:51 PM
Thanks! But I'm not Chris.

If it's not too much trouble could you check the cup depth on the top of the lifter? I'm working on a conversion to hydraulic roller lifters and need to get an idea on a few parts like pushrod and bushing lengths.

Thanks again...

Rzeppa
11-13-2010, 11:39 PM
Hi Frontrange,

We have a Rising Sun member who goes by Frontrange also, and I realized you weren't him and edited my post.

In any case, I'll go grab that lifter and check the depth for you. I thought I had a bag of twelve from the last engine I did, realized I gave them away, but came across a stray when I was digging around looking after your post. I'll check on that tomorrow. Happy cruisin'!

Air Randy
11-14-2010, 09:15 AM
Chris is FrontRange4x4