PDA

View Full Version : Toyota High Steer Arms and Knuckle with 5th Stud mod...$175


Haku
04-09-2012, 03:10 AM
I just upgraded to a FJ80 front axle, and am parting out my old front axle. I'm selling my high steer arms, and the knuckles that go with them. They have been modded with the 5th stud modification, which helps strengthen the steering and will help make sure your steering arms stay attached and tight. Anyone who has wheeled a solid axle Toyota with bigger tires and lockers and such know how this can be a problem.

Here are some pictures...

Newly sand blasted arms
http://hld-illumination.com/haku/Pictures/5thstud1.jpg

http://hld-illumination.com/haku/Pictures/5thstud2.jpg

http://hld-illumination.com/haku/Pictures/5thstud3.jpg

I ground the top of the knuckle flat and drilled a hole the proper size for a Toyota sized lug stud
http://hld-illumination.com/haku/Pictures/5thstud4.jpg

http://hld-illumination.com/haku/Pictures/5thstud5.jpg

A picture when I was mocking it up...its set up for 3 knuckle shims on top and one on the bottom
http://hld-illumination.com/haku/Pictures/5thStud6.jpg

I don't have current pictures of the knuckles yet, but I'll have them midday tomorrow. I'll throw in Trail Gear Rock Rings and the set of Longfield UHMW Lifetime Wiper seals with these for another $20 bucks if you want those too. I think I have spare set of spindles, and I'll let those go for another $30. I need the wheel hubs and disk brakes for another project, but its a good opportunity for you to go to IFS wheel hubs for that extra width.

If you are interested shoot me a Private Message and I'll send a phone number. All of this is currently located at the Club Workshop, which is at 999 Valejo in Denver (East side of I-25 near 8th Ave...close to Denver Bumper and Dazbog Coffee) and I'll be there most of this week working on my truck.

Thanks,

Josh