View Full Version : WTB: Various 80 Series Parts

12-11-2012, 10:10 AM
In hopes of a (very) long trip I want to put together, but have yet to plan, I'm going to start a Wanted to Buy thread. I'll update as I am able to find some of the parts. Some will be used as spares, others need replacement in the near future. Some I'll probably end up getting directly from Toyota but wanted to see if folks have stuff to sell first. I doubt I'll be able to afford/buy all the bits on this list so some prioritization will take place but this is my first draft :-D

Cruiser Bits

ACQUIRED: Eaton or Black Hub Fan Clutch. Old fluid OK.
Later model birfield w/ ABS ring
Front Axle Drive Flange
ACQUIRED: Man A Fre 2" caster drop brackets
ACQUIRED: OEM or slee axle side bushings (0 degree)
Passenger side lx450 headlight
Wheel bearings (for use as spares)
ACQUIRED: Slee transfer case skid plate
ACQUIRED: Passenger Side battery tray and other bits for a dual battery system
1 decent condition 285/75/16 nitto terra grappler (Or maybe a full set of 5 315 Hankook MT's, Nittos or BFG's ;) )
Replacement tie rod ends
Maybe an alternator and starter as spares, but not sure on these yet.\
ACQUIRED: Grommet and plastic clip for 62 series hood strut
Toyota/Denso oxygen sensors

Non Cruiser Bits:

Yakima 1A towers and 76" crossbars.
Partner Steel 2 burner stove
Small propane tank
ACQUIRED: Decent Fluke Multimeter
Scepter gas spout
Maybe another 1-2 scepter gas cans
ARB awning (Smaller)
Offroad or marine type solar panel
ACQUIRED: Howling Moon or Eezi-Awn 1.2
Piece of UHMWPE or similar plastic in a size that I could replace the carpet on the rear tail gate.

I'm sure there are other things I'll think of, but wanted to get a list started incase folks have various bits floating around :)

12-11-2012, 10:53 AM
Josh @ AJIK Overland Exchange is parting out a '95 80 Series. http://forum.ih8mud.com/parting-out/662892-il-95-fzj80-black-tan-part-out.html

12-13-2012, 10:36 AM
Cool thanks I'll check that out.

02-19-2013, 03:44 PM
2 month bump :) Was able to get a new fan clutch, MAF drop brackets, Slee dual battery kit and xfer skid plate, and a new RTT. :D Still lots to go!