PDA

View Full Version : Brake line clips


baja1d
03-25-2013, 11:18 AM
Have anyone ever seen these brake line clips? They're welded to both my axle housings & are 1.5" wide. If so, any idea what the other part that attaches to the brake line is called? Or where I could get it?324543245532456


Sent from my iPhone using Tapatalk

Travis

DanS
03-25-2013, 11:58 AM
Do you just run the brake line parallel to those things, and then zip tie between the two, or just attach them using a hose clamp?

subzali
03-25-2013, 12:57 PM
Are those factory?

baja1d
03-25-2013, 01:00 PM
I have no idea. I'm currently running them parallel & using zip ties but I thought that there might be a bracket designed for the set up that was "more permanent"


Sent from my iPhone using Tapatalk

Travis

baja1d
03-25-2013, 01:01 PM
Are those factory?

Doubt it. They're not on my other stock '76 axle. I think the PO added them in the rebuild


Sent from my iPhone using Tapatalk

Travis

Corbet
03-25-2013, 01:26 PM
I've never seen anything like that OEM. Looks like a zip tie mount. Did it have hard or flex lines crossing the housing?

baja1d
03-25-2013, 03:57 PM
I've never seen anything like that OEM. Looks like a zip tie mount. Did it have hard or flex lines crossing the housing?

No idea. I'm planning on running a hard line.


Sent from my iPhone using Tapatalk

Travis

LARGEONE
03-28-2013, 08:30 AM
Those were definitely added. I did something similar to run wiring on my truck.

AxleIke
03-29-2013, 09:51 AM
Those look like 1/2 of a chain link cut and welded to the housing. You can probably buy it at your local Depot, or Ace for a buck a foot or something similar.

LARGEONE
03-29-2013, 07:17 PM
I used the large Electrical Staples...cut them off and welded them. This way I can zip-tie to the staple and remove/replace as often as I like.

The ones on your axle are a bit larger than the ones I welded on, but same idea.