PDA

View Full Version : Still hoping to find a 60/62 Drivers Fender


cocruiser62
09-03-2013, 03:07 PM
Hi everyone,
Rover67 helped me out with the passenger side. So now I'm super motivated to get the driver's side and get the body work under way. Any help or referrals is appreciated. Desperately hoping not to have to order one.
Thanks again!
Dave

RedCreeper
09-03-2013, 07:41 PM
look a few posts down.

cocruiser62
09-03-2013, 07:55 PM
Thanks Kenny. I did. FJ Mark's post was from Nov 2012. It showed up high today because I replied to it. Mark responded that the fender was gone so I created my post from today.
Appreciate everyone's help.
Dave

Art Volmer
09-03-2013, 09:35 PM
pm sent

cocruiser62
10-25-2013, 10:29 AM
Hi everyone,
Still looking for a good shape drivers fender 60/62.
Appreciate it.
DS

DanS
10-25-2013, 08:22 PM
Hi everyone,
Still looking for a good shape drivers fender 60/62.
Appreciate it.
DS

How quickly are you needing one?

I'm likely to have one, in a while.

Note: before I get to having a spare, I've got to swap an engine into Dad's 60, rebuild (or replace the IP) on a 1HZ, and then install it into my 60.

So, realistically sometime next spring/summer before I can start parting out the body of the Guzzler...

Dan

cocruiser62
10-26-2013, 08:19 AM
Hi Dan,
I'm probably in a bit more of a hurry than that, but please keep me in mind when the time comes. I'd like to find one sooner, but being realistic about that -- and very much avoiding paying the ticket to get an SOR replacement delivered. Thanks! Dave

DanS
10-26-2013, 08:26 PM
Hi Dan,
I'm probably in a bit more of a hurry than that, but please keep me in mind when the time comes. I'd like to find one sooner, but being realistic about that -- and very much avoiding paying the ticket to get an SOR replacement delivered. Thanks! Dave

You got it.

At least now you know there's one that will be available sometime in the almost near future. ;)

Dan

DanS
11-25-2013, 01:30 AM
Just a quick follow up for you DS:

In Ft. Collins there's a 62 being parted out that had what looked like a good driver side front fender (warning: it was dark, and it wasn't the focus of my attention).

Here's the thread on iH8MUD: http://forum.ih8mud.com/parting-out/770189-88-fj62-co.html

Dan

cocruiser62
11-26-2013, 07:38 AM
I'll check it out! Thanks Dan. Really appreciate the tip.
DS

cocruiser62
12-02-2013, 10:09 AM
Hi Dan,
I was able to get a fender off of the cruiser in FC. Thanks for the tip. Just a little surface rust sanding and treatment to do around the vent, but not bad at all and WAAAAAYYYYY better than what I have. Thanks again!
DS