PDA

View Full Version : F engine and goodies


TonkaToy
01-29-2014, 04:14 PM
I have a complete F engine I am looking to find a home for. The rear main seal was leaking and that caused the pilot bearing to bind up/squeal. but, other than that, it ran great when pulled...and, ironically, I have a new rear main seal for it.
It's a compete unit, 3spd trans and PTO included.
It does have a 'Jim C' carb on it and I have a stock carb as well.
Header and complete exhaust also available and rust free.
Non factory PTO winch and shaft. I also have the hard to find little PTO stick 'gate' for it.
Radiator is available too. It may need to be sealed, it was seeping at the top 'cap' when I pulled it.
Complete front heater set up, from core to fan. I am replacing it with a new Vintage Air unit.
Stock, non power, steering gear - from rag joint to pitman.

Prices negotiable, tell me what you need and let's make a deal.
If you want pictures of anything, let me know too.

Thanks!

nuclearlemon
01-29-2014, 05:46 PM
what vintage? and what brand pto?

TonkaToy
01-29-2014, 05:52 PM
73. The winch is a Rhino and the PTO gearbox appears to be stock, no other markings on it.
It's the one that you looked at the carb on last year but it was the wrong type, for what you needed.

cruiseroutfit
01-29-2014, 08:35 PM
Hmmm, I've got a 1972 that is in dire need of a drivetrain. Headed to Cruise Moab?

TonkaToy
01-29-2014, 08:46 PM
Not this year, I'm afraid.

cruiseroutfit
01-29-2014, 08:59 PM
Not this year, I'm afraid.

No worries. If I can figure out a way to get it to Moab (or SLC), I may be interested in the lot.

TonkaToy
01-29-2014, 09:05 PM
I can pack and load as needed, just let me know.