PDA

View Full Version : need 2 chunks of square channel


nakman
12-01-2006, 02:43 PM
Anyone have some square channel and could break me off a piece? Or point me to some? I need two pieces, 1 1/2" OD in both directions (square), about 4" long. If 1 1/2" isn't attainable, I could also make 2" work.. also I drew this at .250" wall but that's probably rediculously thick, anything about .125" should work fine. Anyone help? thanks...

lfd270ben
12-01-2006, 03:44 PM
I dont have any with that thick of a wall but you could get it at rose steel in lafayette

nakman
12-01-2006, 04:22 PM
Thanks.. do you have any that's .125" wall? .080" wall? wha chu got? trade ya for some u-bolt plates.. ;)

leiniesred
12-01-2006, 06:00 PM
I have some 2 inch .250 wall stuff I think. (from making square driveshafts)

lfd270ben
12-01-2006, 07:03 PM
I have some 1"1/2 schedule 40 but im not sure how thick the wall is ?

Rezarf
12-01-2006, 11:11 PM
Tim-

I got what you are looking for.

1 1/2 inch square in .125" wall, and I have some 2 inch 3/16" wall. Come by and we can cut you up what you need.

Drew