View Full Version : 80 series 4.11 Gears work in anything else

12-02-2006, 01:50 PM
I think I read somewhere that the ring and pinion out of an 80 would work in a 40 and 60 diff. Anyone know if that's true?

12-02-2006, 01:52 PM
FYI - I found these gears for a friend, don't want them myself. Will see how many people want them and then I will mark up the price:D

OK just kidding (for those who aren't in on the current bashing target)

Uncle Ben
12-02-2006, 02:52 PM
The rear carrier will adapt into a 4x, 55, 6x, with differant carrier bearings.

12-02-2006, 03:29 PM
So they would make good spares for the CM fund. Could be used for multiple vehicles?

12-07-2006, 08:09 AM

I'll have another set available shortly. If you combined the rears you could have a matching set of 4.10s that would be good for somebody with a 40,55,60.

Eric V.

12-07-2006, 08:13 AM
Thanks Eric. These are going to the CM parts fund and it's nice to know multiple uses. Someone with lower gears breaks, we can alwys use these to fix the axle and pull a drive shaft to get them home.

12-07-2006, 08:50 AM
Any rust?

12-07-2006, 10:02 AM
No, I believe they are clean buit I did not give them a detailed look over.

12-07-2006, 11:18 AM
Didn't get the joke?

12-07-2006, 02:38 PM
Didn't get the joke?

I caught it and chuckled ;) :beer: :D

12-07-2006, 03:27 PM
Didn't get the joke?

I forgot i made a razor joke earlier:D

12-07-2006, 04:36 PM
Depending on what you want for them Romer, I sure could use a fine spline 4.11 gear set for my cruiser...

12-07-2006, 06:59 PM
I was planning on donating them to the cruiser parts collection. My price to you would be something as valuable to the cruiser parts fund that we might need,

I know we could have used these. Even if it was to repair a diff to get it home and remove the other shaft due to different gears.

12-07-2006, 11:30 PM
good on ya, I missed that post, I can find another source no worries.