PDA

View Full Version : T/case ?


art hog
01-11-2007, 07:22 PM
Does anyone know the size and length of the bolts that hold the front output housing on a 3spd t case. Mine seperated from the t/case I hope I caught it in time. also is it hard to pull the rear axel with ARBs It appears that the seal or bearing race is bad. I have oil covering my pass. side rear tire.

Terry


If this keeps up I might know of a 55 with 4BT for sale:rant:

Hulk
01-12-2007, 04:17 PM
Which bolts?
http://www.sor.com/shared/image/068-100_01-big.jpg

Hulk
01-12-2007, 04:19 PM
This diagram might be even more helpful:
http://www.sor.com/shared/image/068A1.gif

http://www.sor.com/sor/cat068.tam?xax=4002

wesintl
01-12-2007, 04:29 PM
I'm thinking #33.. No way i'm going outside to get under my truck and pull one to measure right now. Hopefully someone has one handy for you. :cheers:

art hog
01-12-2007, 06:20 PM
yes. #33

Hulk
01-13-2007, 12:59 AM
Specter Off Road sells them for $1 each (http://www.sor.com/sor/products2.tam?xax=4581&pagenumber%2Eptx=1&category%2Ectx=068%2D33&pagenumber%2Eptx=1&page%23%2Ectx=068). You could call them and find out what they are. Or just order them and save yourself the hassle of driving all over trying to find the right bolts. ;)

60wag
01-13-2007, 07:59 AM
From Matt's picture, they look like blind holes that aren't very deep. You might just stick the end of a caliper in the hole to find the max depth for the bolt. If the bolts pulled out and buggered the threads, you might consider a helicoil repair.

As for the axle seal... The C clips in the diff have to come off to get the axle out. The ARB is similar to the stock setup but slightly different. There is a downloadable ARB install manual in the Tech section on Mud that should show the details.