PDA

View Full Version : flange ID


bigbluefj
03-20-2007, 07:32 PM
so here's the deal the drive shaft shop screwed up the yoke on my front drive shaft, when they were doing the ujoint's they put a bigger yoke so now it does not match with the tcase flange. The problem they lost or misplaced the yoke that was on the shaft when droped off at there shop, so now i have to find a matching yoke the tcase flange is a small bolt pattern and is on my 74 tcase i need it to be small to clearence the tranny which is a sm420, here's a couple of pic's if any one could tell me what year of drive shaft i should be looking for ????

kevin

cruiseroutfit
03-20-2007, 09:07 PM
Check this out :D
http://www.cruiseroutfitters.com/tech_flange.html

Looks like the 4spd pattern to me...
11mm ID Bolt Hole - 68.5mm x 60mm pattern.

treerootCO
03-20-2007, 09:56 PM
Sorry Kevin I forgot to grab you number before I heading out to work this morning. If you need anything call my cell, I'll remember to grab it tomorrow.

Red_Chili
03-21-2007, 07:17 AM
Holyrunonsentencebatman...

bigbluefj
03-21-2007, 07:26 AM
sorry bad day

kevin.

Hulk
03-21-2007, 10:40 AM
Kevin, sorry I didn't call you back. I'm crazy at work and trying to take 2 days off to leave town for the Hotel Rock pre-run. You're better off asking here anyway, since my knowledge on drive shafts is limited.