PDA

View Full Version : Air Locker fitting


DaveInDenver
05-09-2007, 10:47 AM
Anyone know where (or if) I can get this part of the bulkhead fitting? This is the little part where the tube from inside the diff comes together with the blue hose. BTW, this little part is no match for the diff housing-to-garage floor impact when your front diff assembly rolls off your jack as you're trying wrestle it into place...

Red_Chili
05-09-2007, 11:04 AM
I believe A&A Tradin' Post may have it. Should be NPT and compression fitting sizes. No kiddin'!

If not, TRBurris@ARBUSA.com should be able to fix you up.
(206) 264-1669

nuclearlemon
05-09-2007, 11:42 AM
arb uses odd sizes so i retapped mine to take 1/4" air lines/1/8 npt

Man Jerk
05-09-2007, 12:38 PM
You could always call Steve Cramer (Poser on ih8mud). I'm sure he's got them in stock.

www.lcr4wd.com

Three Wheel Ben
05-09-2007, 02:00 PM
Marlin sells them, not local though.

FWIW, my email to this address was bounced and the area code for ARB USA is now (425). I am going to call tech support at ARB and just ask them.

Red_Chili
05-09-2007, 02:40 PM
FWIW, my email to this address was bounced and the area code for ARB USA is now (425). I am going to call tech support at ARB and just ask them.
Thanks for that. I got the contact info from an article I wrote on 4x4wire.com for Project Blackbean.

I guess no career is permanent! Parts should be easy to get from them, never had a problem.

AxleIke
05-10-2007, 03:51 AM
McGuckins hardware in boulder. I messed up one of my fittings, went down there, got it out of a bin. Also built my pressure tester that way.

60wag
05-10-2007, 06:28 AM
It might be BSP (British Standard Pipe) thread rather than the usual NPT. I ran into that on the solenoid manifold on the ARB compressor.