PDA

View Full Version : Toyota truck/4runner IFS Calipers


PatrolMan
08-15-2007, 10:12 PM
Looking for a set that someone has sitting around. Prefer to buy online rather than from the salvage yard... Thanks!

Bighead
08-16-2007, 06:43 AM
Let me check my garage...I may have a set from a 99 4Runner laying around. Would that work for you if I stil have them?

Red_Chili
08-16-2007, 07:38 AM
99 won't if I gauge correctly what PatrolMan needs (for a solid front axle conversion?). Although you might be able to use them as cores?

Yoda Man (Jim Wales, the former owner of Yota Yard) has decent deals at his junkyard though. He is far less pricey than Yota Yard has become.

PatrolMan
08-16-2007, 08:25 AM
That is correct, 99 is too new. They aren't for a solid axle conversion, but rather another "project" that calls for IFS calipers. Believe that 86-95 are appropriate years. I have never been to Yota Yard. Worked with Jim though on a couple occasions.

nuclearlemon
08-16-2007, 10:32 AM
check with oleg and yuiry at irbis off road also. they do some pickup stuff too.

hykerwilson
09-09-2007, 03:31 PM
I know that you are looking to get from someone online and not a salvage yard. How much are you looking to pay?

The "U" pull it down in the springs has 3 trucks / runners that have what you want. I picked up a set of hubs for 10.00 each last week. let me know what you want to pay, and I pull it off for you and charge minimal, of course depends on the time.

these trucks seem rather clean. just wrecked. ifs parts look fine.

Hyker
Hykerwilson@gmail.com

PatrolMan
09-09-2007, 07:05 PM
The yard here has them on their trucks. They are plentiful. They charge $10 a piece. I just thought I would help someone clean their garage. I don't need them until the end of this project. Will take them now if someone has a set to get rid of. Otherwise will scoot over to the yard at a later date.

bskey
09-25-2007, 02:50 PM
I am interested in these too hykerwilson, but am in the springs often and am willing to go grab them myself. I also want an fj master cylinder too, so I have a few things to pick up. Where is this yard located and what's their name?

Thanks!

PatrolMan
09-25-2007, 03:47 PM
Just finally grabbed a nice set at the yard near my house for $10 each. Also looking for a set of solid axle calipers. Not in a hurry... Again, would prefer to clean out someones garage rather than pay the man.

bskey
09-25-2007, 03:48 PM
PatrolMan, where did you go in Englewood? I am in Parker and that would be easier......

PatrolMan
09-25-2007, 05:32 PM
Went to Colorado Auto Parts. It is off Santa Fe between Oxford and Belleview. It is behind Svigels along the frontage road. $10 a caliper. There were several IFS 4runners and trucks yesterday, some had calipers. I only needed 1 set.

bskey
09-25-2007, 08:24 PM
Nice! Thank you!!!

PatrolMan
09-25-2007, 10:16 PM
Not a problem. Most of the 4Runners were 90+. When you get to the truck section, most of the 4Runners were to the left side. The main aisle puts you into the middle of the trucks. Wasn't much to the right. Good luck!