PDA

View Full Version : Cut & Turn Question


Air Randy
09-08-2008, 04:47 PM
Can anyone recommend a good place to go in Denver or Colorado Springs that can do a cut & turn on my front SOA axle? Any idea how much this usually costs?

Same question in regards to where I can go to have a long travel front & rear drive shaft made to fit my 1974 FJ40?

Hulk
09-08-2008, 04:59 PM
Question 1.
Irbis Offroad
Rocky Mountain Cruisers
Colorado Toyota Specialists

Question 2.
Englewood Driveshaft

subzali
09-08-2008, 05:44 PM
Question 1.
you can also ship to Proffitt's Cruisers out in Montrose, or send it to Kurt at Cruiser Outfitters. If you care to ship it out of the area.