View Full Version : On Board Air York 210 on Vortec

01-06-2009, 08:26 PM
thanks for the input from the guys on this board :beer:

here's a link to the thread over in mud i posted describing the on board air setup. I love it. I have used the compressor a ton already.. for everything from air blowers to air wrenches and fillling tires. It blows a ton of air.


01-07-2009, 09:46 AM
nice write up.

01-07-2009, 10:27 AM
Which U-Pull-It did you search around?

01-07-2009, 11:04 AM
Wow, very nice. I'm planning to install compressed air on my 80 this spring -- I'll be looking at your thread a lot!

01-07-2009, 01:15 PM
The U Pull & Pay on:

1445 Zeno St
Aurora, CO 80011

Is there a better one? They had lots of old heeps and internationals and volvos with 209's and 210's

01-07-2009, 02:27 PM
I really didn't know where to check?

I was checking out 60WAGs setup in his '96 80 during the Snow & Pizza Run and it looked like a great set-up as well. I guess I'll have to read up on which York model is needed for the 80?

01-07-2009, 03:43 PM
most people go with the 210's. you either have to come up with or make a bracket for them to fit. The 209's have a bit smaller displacement. In that mud thread is a link to another thread that has all of the applications the 210's came in listed.

01-07-2009, 08:04 PM
So what would the part number be for the Serpentine clutch pully would like to get the same one as yours??


01-07-2009, 11:48 PM
this is the one I bought:


but I really don't see why this one wouldn't work....


I know it sounds silly but I kinda wanted a one wire one...