PDA

View Full Version : Need to Borrow Harmonic Balancer Pulley Puller


RicardoJM
02-28-2009, 03:00 PM
The NAPA here no longer loans/rents tools and both of the Checker stores have their pullers currently out. Is there anyone on the south side that I would be able to borrow the puller from?


I just need to remove my single row pulley. I already have the big ole nut off, so it should not take long. I'm off to do some errands for a couple of hours and will be checking back in the late afternoon.

DaveInDenver
02-28-2009, 03:37 PM
The NAPA here no longer loans/rents tools and both of the Checker stores have their pullers currently out. Is there anyone on the south side that I would be able to borrow the puller from?


I just need to remove my single row pulley. I already have the big ole nut off, so it should not take long. I'm off to do some errands for a couple of hours and will be checking back in the late afternoon.
I think I know what a 2F balancer puller looks like, but I don't have one specifically. However, I have a few OTC pullers (slide hammer kit, bar-type puller, 2-jaw puller) that you are welcome to give a once over to see if any of them will fit the bill.

http://www.otctools.com/newcatalog/products/522_4561.jpg

http://www.otctools.com/newcatalog/products/7948_2971.jpg

http://www.otctools.com/newcatalog/products/1035_13.jpg

Hulk
03-01-2009, 12:53 PM
I have a puller you can use, and I live really really close to you. :)

RicardoJM
03-01-2009, 07:06 PM
Thanks for the offer, but I went ahead an picked one up at NAPA. It worked great, old one off and new one on. :D