Rising Sun Member Forums  

Go Back   Rising Sun Member Forums > Jacket

Conversation Between Jacket and MDJ
Showing Visitor Messages 1 to 5 of 5
  1. Jacket
    07-21-2010 10:45 PM
    My CB antenna was on my ARB front bumper. I'm not a huge CB/radiophile, but I think that you might get a slightly better ground plane if you are near the hood (using one of those hood lip mounts) due to the large surface area of the hood (as opposed to the back bumper and composite bed). The only downside the the front location is that you'll have to look at the antenna when you are driving (which isn't a big deal in my opinion).
  2. MDJ
    07-20-2010 10:00 PM
    I am about to order a CB. I was wondering where you placed your antenna would it be better attached to side of the hood or on the back bumper?
  3. Jacket
    07-09-2010 08:07 AM
    I didn't post any of the FS items here. I can email you the links on TTORA, although I may have a buyer for the skid plates already.
  4. Jacket
    07-09-2010 08:06 AM
    Hey Michael,

    Here's what you'd need:

    90404-51319 - Union
    90930-03136 - breather vent
    zip ties
    two stainless steel hose clamps
    5' of 3/8 fuel line

    The current diff breather screws into the top of the rear diff (drivers side of the pumpkin IIRC). Unscrew it, and screw in the union. For the extension, I ran mine to the fuel door. Drill a small hole in the plastic surrounding the filler neck, and attach the breather vent to the fuel line and clamp it. Run the hose down to the union on the diff, and clamp it there. Tie off the hose to keep it clear of things, and make sure there is enough slack in the hose to allow your suspension to droop.
  5. MDJ
    07-08-2010 08:30 PM
    Hey man it's Michael. Thank you for all of the knowledge on the taco last night. I would definitely like to get the part numbers for the diff breather parts. My email is mdj719@gmail.com. Also I was looking for your post on the parts you have for sale for the taco I havenít been able to navigate to well on the forum to find them.

    Thanks man,

    Michael Jones

All times are GMT -6. The time now is 02:18 PM.

Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.