Rising Sun Member Forums

Rising Sun Member Forums (http://www.risingsun4x4club.org/forum2/index.php)
-   Ham & CB Radio Corner (http://www.risingsun4x4club.org/forum2/forumdisplay.php?f=20)
-   -   Trying to wire an ext mic into an old handheld CB (http://www.risingsun4x4club.org/forum2/showthread.php?t=15193)

CO Hunter 03-01-2011 06:31 PM

Trying to wire an ext mic into an old handheld CB
 
Don't know if this is more trouble than it is worth but here it goes. I have a close to 20 year old Realistic handheld CB with no ext mic connector. It works fine for trail rides but it would be nice to have an external mic.

I took the radio apart and found the ppt button activates a 3-pole micro switch. Pole 1 is black, I'm guessing is ground and there is a g next to the pole. The second, middle pole has one wire and has NO stamped next to it, normally open, I would guess. The third pole has one wire and is stamped NC, for normally closed, I'm guessing. The internal mic has 2 wires, a black and a white, that go into the circuit board. On the micro switch it is difficult to trace the wires into the circuit board.

I found this http://www.eriecb.com/pin_layouts.htm

Cobra, Uniden, Teaberry, President, Tram, Galaxy, Connex, Super Star, Ranger, Northstar, Mirage, Virage, Northpoint and Others


Pin 1 = Ground / Shield


Pin 2 = Modulation


Pin 3 = Transmit (TX)


Pin 4 = Receive (RX)

Can anyone give guidance on a mic and the connections to make?


All times are GMT -6. The time now is 09:09 AM.

Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.