Rising Sun Member Forums

Rising Sun Member Forums (http://www.risingsun4x4club.org/forum2/index.php)
-   General Tech Forum (http://www.risingsun4x4club.org/forum2/forumdisplay.php?f=17)
-   -   Factory Roll Bar Location? (http://www.risingsun4x4club.org/forum2/showthread.php?t=19403)

kvanoort 04-07-2013 09:27 AM

Factory Roll Bar Location?
 
I'm installing a Metal Tech Full Profile Cage into my '72 40 and need location measurements of the bolt holes for a factory roll bar on the wheel wells. My vehicle didn't come with a factory roll bar and the rear mounting plates for the cage use the factory bolt holes to correctly position the base plate. If someone could measure the distance of the roll bar bolt holes from the front and side edges on the wheel well and post them up I would greatly appreciate it. Thanks.

Jacket 04-08-2013 01:36 PM

Swing by this evening and we can take a look.

Rzeppa 04-08-2013 05:07 PM

Look at the passenger side forward measurement, the top right hole is measured from the inside edge of the quarter panel. In reality, even with an aftermarket roll bar there's really only one way to orient it relative to the fender wells.

http://rzeppa.org/resto/meas.gif

kvanoort 04-09-2013 03:01 PM

Based on the measurements I took from Matt's factory roll bar and Jeff's CAD (Crappy Ass Drawing) :-), I have what I need to position the Metal Tech cage. Thanks Gents!

L43dean 04-09-2013 07:56 PM

http://rzeppa.org/resto/meas.gif[/quote]

This needs to be a Rising Sun T-Shirt.


All times are GMT -6. The time now is 11:39 PM.

Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.