Rising Sun Member Forums

Rising Sun Member Forums (http://www.risingsun4x4club.org/forum2/index.php)
-   General Tech Forum (http://www.risingsun4x4club.org/forum2/forumdisplay.php?f=17)
-   -   Picture needed - OEM fuel line routing (http://www.risingsun4x4club.org/forum2/showthread.php?t=19668)

subzali 05-29-2013 09:53 PM

Picture needed - OEM fuel line routing
 
I need a picture of the bracket at the front of the valve cover that holds on to the OE fuel lines. Which line clips into which clip? My specific application is a 1977 FJ40 but anything in the near vicinity should be the same.

nakman 05-29-2013 10:27 PM

3 Attachment(s)
is this it?

Rzeppa 05-30-2013 12:35 AM

I see both send and return lines in the bracket in the photos, and in the photos it looks like they are in the factory clip. My recollection is that the supply is on the top and the return is on the bottom. I doubt it matters which is on top or bottom.

subzali 05-30-2013 07:00 AM

Yep, thanks Tim. It's a little hard to see on my phone, but there is a clip on the side of the bracket and I'm not sure which line that is supposed to hold.

Jeff, you are probably right that it doesn't matter. I just need to do a little more pushing and pulling to get my fuel lines lined up right

Jacket 05-30-2013 11:18 AM

I looked at mine and found that the return line was rubbing pretty significantly on the bypass hose for the radiator. There is a nice little divot on the hose...

So thanks for bringing this to my attention. :) I'm guessing mine is not set correctly, but I'm not sure why. There is plenty of "play" in that return line to move it back toward the head, but I had to zip tie it off to hold it away from the hose.

simps80 06-23-2014 12:55 AM

Ok revival...
The bracket at front valve cover...does it mount behind lower thermostat housing on ps side bolt???

Also does anyone have a good pick of the fuel line bracket mounting for these same 2 hard lines (i think) down by fuel pump??

Thanks in advance!

Rzeppa 06-23-2014 10:36 PM

Just took a peek at my 76. It's super straightforward. Back with pics shortly

treerootCO 06-24-2014 10:24 AM

3 Attachment(s)
I found the Canada Spec 2 of 76 to 4 of 79 fuel line pic

Attachment 37723

1/75 to 2/76

Attachment 37725

this pic has the one additional bracket the fuel filter bolts to

Attachment 37724

simps80 06-24-2014 10:37 AM

yep 25 and 26 where do those mount on the engine

I am fairly certain 26 is bolted to the lower thermostat housing PS bolt, cause that lines up fairly accurately

25 though..I 'think' that must bolt through one of the side cover bolts but not sure

subzali 06-24-2014 04:12 PM

26 bolts to a place that is open to the water jacket. My 40 isn't at home so I can't grab a pic


All times are GMT -6. The time now is 10:54 PM.

Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.