Rising Sun Member Forums

Rising Sun Member Forums (http://www.risingsun4x4club.org/forum2/index.php)
-   General Tech Forum (http://www.risingsun4x4club.org/forum2/forumdisplay.php?f=17)
-   -   FJ60 axle dimensions (http://www.risingsun4x4club.org/forum2/showthread.php?t=7456)

subzali 06-22-2008 09:18 PM

FJ60 axle dimensions
 
Those of you with 60 series axles...can you take a measurement for me from backing plate to backing plate (inside dimension)? I need to double check something...

Groucho 06-23-2008 07:04 AM

If I remember, I'll do it when I get home.

rover67 06-23-2008 08:00 AM

ditto..

subzali 06-23-2008 08:17 PM

bump

RicardoJM 06-23-2008 08:39 PM

Matt, I just stepped out and measured mine at 53.5" from the outside edge of the knuckle to the outside edge of the knuckle. I think this is where the backing plate goes, but could be wrong. Basically if you look at the pictures in my disc brake conversion thread - I measured from end to end of what is sitting on the jack stands, not including the birfields hanging out of the knuckle.

subzali 06-23-2008 08:43 PM

Thanks Ricardo, that'll get me close, but the front axle should be slightly wider than a rear axle (for tracking purposes I think), plus the backing plates are a little different. I'm hoping to get a good solid number for the rear axle, especially since the one you just gave me has me wondering...

MDH33 06-24-2008 11:58 AM

I just measured the rear and it's also 53.5" from the outside edges of the axle housing where the brake backing plates bolt up.


All times are GMT -6. The time now is 07:44 AM.

Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.