Rising Sun Member Forums

Rising Sun Member Forums (http://www.risingsun4x4club.org/forum2/index.php)
-   General Tech Forum (http://www.risingsun4x4club.org/forum2/forumdisplay.php?f=17)
-   -   Red vs. Blue (http://www.risingsun4x4club.org/forum2/showthread.php?t=8460)

theboomboom 10-29-2008 10:25 PM

Red vs. Blue
 
Hey all, here's my situation.

The bronco has been wanting to spit out its driveshaft lately. The last work done to it was a clutch replacement a few thousand miles ago, and in the past few hundred miles i noticed a vibration in the drivetrain. Hop under the rig, and I'm able to spin the driveshaft bolts with my finger :eek:. I cinched everything back up, under the assumption that they had not been torqued by the guy that did the clutch. A couple hundred more miles, and I'm experiencing similar symptoms. Re-check everything, and sure enough, they were loose again. Now I'm at a crossroads. There are no locking washers, or any other hardware to keep it from happening again. I plan on contacting a tech from one of the dealers nearby to find out if it needs some locking hardware. In addition to the hardware, I plan on using some threadlock. The poll at the top is whether I should use the blue, or heavy duty red. The truck has ~121k, basically stock, it's been routinely maintained, but there could be a lift in its future. Obviously, I don't want to fuss with the driveshaft bolts again untiil then, so I'm leaning towards the red. When/if it gets lifted, is it really the end of the world to try and free those bolts? Is the blue adequate in the interim?

Thanks

nuclearlemon 10-29-2008 10:44 PM

i'm a big fan of red.

SteveH 11-11-2008 06:16 PM

I'd use red - blue (esp. on older/greasier stuff) doesn't hold all that well. If the bolt threads are badly worn, replace the bolts themselves.

Red_Chili 11-12-2008 11:52 AM

On drivelines, always use red.


All times are GMT -6. The time now is 03:54 AM.

Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.