Rising Sun Member Forums

Rising Sun Member Forums (http://www.risingsun4x4club.org/forum2/index.php)
-   General Tech Forum (http://www.risingsun4x4club.org/forum2/forumdisplay.php?f=17)
-   -   80 exhaust ? (http://www.risingsun4x4club.org/forum2/showthread.php?t=8621)

nuclearlemon 12-02-2008 10:00 PM

80 exhaust ?
 
2 Attachment(s)
why couldn't the 80 headers be collected a bit higher up, than a single exhaust with a heat shield be run down through here, instead of going outside the frame rail, then underneath it to return back inside again?

Uncle Ben 12-02-2008 10:14 PM

That would put the cats too close to the tranny.

Beater 12-03-2008 06:48 AM

does anyone know of someone installing a single high flow cat?

Uncle Ben 12-03-2008 07:46 AM

Quote:

Originally Posted by Beater (Post 90851)
does anyone know of someone installing a single high flow cat?


Many folks run a single high flow. I am running a single 3" high flow spun with 0 MIL problems.

nakman 12-03-2008 08:14 AM

Quote:

Originally Posted by Uncle Ben (Post 90854)
Many folks run a single high flow. I am running a single 3" high flow spun with 0 MIL problems.

no mother in law problems? well there's a benefit... :eek: :lmao:

Uncle Ben 12-03-2008 08:31 AM

Quote:

Originally Posted by nakman (Post 90858)
no mother in law problems? well there's a benefit... :eek: :lmao:

I never said that! :rolleyes: :rant: ;)

Nay 12-03-2008 01:18 PM

I need to do something, my exhaust is absolutely mangled where it runs back under the frame. My muffler is mangled. I need a high clearance, low cost, not loud(er) solution :D

nuclearlemon 12-03-2008 01:25 PM

i've got single cat, wouldn't be any closer than it is now

Beater 12-03-2008 03:58 PM

there's gotta be a way to modify supra headers to fit... maybe root will go there for us

j

Uncle Ben 12-03-2008 04:11 PM

Quote:

Originally Posted by nuclearlemon (Post 90901)
i've got single cat, wouldn't be any closer than it is now

The outside of the frame rail is as close as between the rail and tranny? :confused:


All times are GMT -6. The time now is 02:03 PM.

Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.