Rising Sun Member Forums  

Go Back   Rising Sun Member Forums > Search Forums

Showing results 1 to 25 of 193
Search took 0.09 seconds.
Search: Posts Made By: thefatkid
Forum: For Sale / Wanted 10-20-2014, 12:59 PM
Replies: 10
Views: 185
Posted By thefatkid
I'm down in Littleton if you frequent this...

I'm down in Littleton if you frequent this direction.
Forum: General Tech Forum 10-20-2014, 12:56 PM
Replies: 5
Views: 108
Posted By thefatkid
If the sensor was a open or short circuit it...

If the sensor was a open or short circuit it would set a code. Older ABS systems have issues detecting and setting codes for variances in the sensor waveform. If your wheel bearing is loose and...
Forum: General Tech Forum 10-19-2014, 12:27 PM
Replies: 5
Views: 108
Posted By thefatkid
With the damaged rear sensor, were the wheel...

With the damaged rear sensor, were the wheel bearings tight? When was the last time you cleaned and regreased the rear wheel bearings?
Forum: General Tech Forum 09-25-2014, 11:12 AM
Replies: 6
Views: 157
Posted By thefatkid
Also note that in the current state of that truck...

Also note that in the current state of that truck it will not pass emission inspection the boulder county (or any emission county).
Forum: General Tech Forum 09-25-2014, 11:11 AM
Replies: 6
Views: 157
Posted By thefatkid
I just sold my 22r powered 1983 Toyota pickup for...

I just sold my 22r powered 1983 Toyota pickup for $2500. It had a quality lift (OME) and 4.88 gears and electric locker in the rear. I'd say it seem high in price.
Forum: General Chit Chat 09-18-2014, 08:11 AM
Replies: 23
Views: 437
Posted By thefatkid
How long till you trade it for a horse?

How long till you trade it for a horse?
Forum: General Tech Forum 08-15-2014, 09:10 PM
Replies: 5
Views: 113
Posted By thefatkid
I'm going to try and make the rally. I have an...

I'm going to try and make the rally. I have an older 9.5xp and could bring the controller for that one. It is a 5 pin with a built in light. I could bring the solenoids also as it is between...
Forum: For Sale / Wanted 06-12-2014, 04:45 PM
Replies: 11
Views: 261
Posted By thefatkid
Do you ever venture up to Denver?

Do you ever venture up to Denver?
Forum: General Chit Chat 06-07-2014, 08:10 AM
Replies: 6
Views: 130
Posted By thefatkid
Never try and stop a moving/rolling vehicle with...

Never try and stop a moving/rolling vehicle with your body. Don't jump towards a vehicle in motion. While the throttle out to save from a "roll" might have been not needed, it was just dumb to try...
Forum: For Sale / Wanted 04-02-2014, 08:39 PM
Replies: 1,607
Views: 110,457
Posted By thefatkid
Isn't that Ige's old LC? I think the seller was...

Isn't that Ige's old LC? I think the seller was below $9500 at one point this winter.
Forum: General Tech Forum 02-20-2014, 12:00 PM
Replies: 10
Views: 252
Posted By thefatkid
1st, you have to make sure the registered key you...

1st, you have to make sure the registered key you are using is a "master key". Is the key a factory Toyota key? Is it black?

2nd, this vehicle has a maximum number of 4 master and 2 sub keys allowed...
Forum: General Tech Forum 11-15-2013, 09:41 PM
Replies: 2
Views: 141
Posted By thefatkid
Do you already have a lift? Are you looking to...

Do you already have a lift? Are you looking to lift?

I really like my OME suspension. I have installed a couple of those newer Bilstein adjustable coil overs and they work/ride really well.

For...
Forum: General Tech Forum 10-15-2013, 10:22 AM
Replies: 17
Views: 417
Posted By thefatkid
Groove Toyota uses machines that flush 16 quarts....

Groove Toyota uses machines that flush 16 quarts. BG flush machines. It flushed using the vehicles power to replace the same amount of fluid going in and out. I think Toyota still says the fluid is...
Forum: General Tech Forum 10-08-2013, 09:19 PM
Replies: 3
Views: 166
Posted By thefatkid
The engine ecu is also the transmission control...

The engine ecu is also the transmission control ecu. You will need the harness and ecu for the model/year vehicle. Some of the body harnesses have different plugs when switching from manual to...
Forum: For Sale / Wanted 09-23-2013, 09:22 PM
Replies: 5
Views: 419
Posted By thefatkid
Wow, If I had my 83 pickup sold I would jump on...

Wow, If I had my 83 pickup sold I would jump on that.
Forum: For Sale / Wanted 09-07-2013, 06:06 PM
Replies: 1,607
Views: 110,457
Posted By thefatkid
No, he paid for an EMO lift, that explains...

No, he paid for an EMO lift, that explains everything.
Forum: General Chit Chat 08-13-2013, 08:40 PM
Replies: 25
Views: 1,013
Posted By thefatkid
If they are parting them out here, they do a good...

If they are parting them out here, they do a good job keeping them off of craigslist.
Forum: General Tech Forum 08-13-2013, 08:39 PM
Replies: 2
Views: 262
Posted By thefatkid
Is it a manual or auto? The front end parts are...

Is it a manual or auto?

The front end parts are bolt in. The transmission is not the same between the 4cylinder and 6 cylinder so you would need to source a 4wd v6 tranny and t-case.
Forum: General Tech Forum 07-31-2013, 09:03 AM
Replies: 12
Views: 456
Posted By thefatkid
I was thinking of buying the other set. I'm not...

I was thinking of buying the other set. I'm not sure 4.88s will be good with the supercharger and 80mph though. I was almost thinking a crawler is a better option.

If you decide to buy it, I'll buy...
Forum: General Tech Forum 07-25-2013, 09:26 AM
Replies: 12
Views: 456
Posted By thefatkid
Being a 4 cylinder you might want to wait....

Being a 4 cylinder you might want to wait. Though, if you only stay with 33s the 4.88s will not be bad at all. Just to compare, my 83 with no power runs 4.88s and 33s without much issue. It feels...
Forum: General Tech Forum 07-15-2013, 08:38 AM
Replies: 11
Views: 475
Posted By thefatkid
Sounds more like a loose or poor connection. When...

Sounds more like a loose or poor connection. When you say your greased the terminals, what did you use? Did you grease an then install the batter cables? Was there a bunch of corrosion prior to this...
Forum: General Tech Forum 07-02-2013, 09:37 PM
Replies: 5
Views: 204
Posted By thefatkid
That doesn't sound right at all. Your alignment...

That doesn't sound right at all. Your alignment guy might be faulty. That Tacoma should have 0 camber if not a little positive camber. Toe should be slightly in also, giving even more of a positive...
Forum: General Tech Forum 07-02-2013, 08:55 PM
Replies: 5
Views: 204
Posted By thefatkid
This is more of a cause of incorrect suspension...

This is more of a cause of incorrect suspension angles. When was your last alignment?
Forum: For Sale / Wanted 06-25-2013, 10:15 PM
Replies: 7
Views: 627
Posted By thefatkid
Do you have a part number for that auger? Would...

Do you have a part number for that auger? Would you be willing to sell separate from the box blade?
Forum: General Chit Chat 06-21-2013, 06:55 PM
Replies: 39
Views: 1,448
Posted By thefatkid
I know western metals will not let you scrap a...

I know western metals will not let you scrap a vehicle without a title. A shady junk yard will always be shady.
Showing results 1 to 25 of 193

 

All times are GMT -6. The time now is 04:27 AM.


Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.