View Single Post
Old 06-21-2009, 11:38 AM
TIMZTOY's Avatar
Hard Core 4+
Join Date: Apr 2009
Location: Denver
Posts: 1,914

more steps 15-20

actually after doing all the cutting .. i reccomend measuring at liest 1" to 1-1/2" from the spot weld A location because the cut was right on the cross member. and was kinda difficult to place a flush scrap under the bed to take up some of the gap made by using a cut off wheel.. i had to use a cut off wheel because the spare tire cross member was only 1/2" below the bed floor
Attached Images
TLCA # 20314
84 Hilux, 22re Conversion, 63" chevy rears, Rears up front, Bobbed bed, duel e-lockers, 5.29's, 35" Ground Hogs low compression
Step by Step Bed Bob
Reply With Quote