View Single Post
  #10  
Old 06-25-2009, 11:00 AM
AxleIke's Avatar
AxleIke AxleIke is offline
Rising Sun Member
 
Join Date: Apr 2006
Location: Arvada, CO
Posts: 3,232
Default

Updates:

Got the rear suspension out, and the new stuff in:


After finishing the rear axle up, I cleanup up a bit, did a lot of organizing, and turned the truck around. Also, due to the extreme generosity of a friend, I picked up a 14" abrasive chop saw for a six pack of beer.

So, I took off my rear axle, and cleaned my frame:



I also began fabbing my frame side bracketry.

Here are my frame plates:





And the back "plates" (rectangular tubes) that will be where the tabs weld to, along with the plates and some square tubular gussets:



And the last of my bling arrived via the UPS man:



18" 300 lb/inch coils
__________________
Isaac

Baby Beast 2- 1999 4Runner SR5

Baby Beast -1987 4Runner SR5-Gone, but not forgotten

Generation Dead
Reply With Quote