View Single Post
Old 06-25-2009, 12:03 PM
AxleIke's Avatar
AxleIke AxleIke is offline
Rising Sun Member
Join Date: Apr 2006
Location: Broomfield, CO
Posts: 4,417

Got more work done.

Truck now moves under its own power.

Got the old crossmember torched out, and the new one put in:

Hole cut for the tank:

Tank in:

This was cool. Lots of clearance under the tank. I didn't think it would sit up that high. Very cool

Lastly, got the horseshoe crossmember dealt with.

Started on the tranny tunnel. One cross piece is all, as it took a little adjustment to change from welding 1/4" to sheet metal. Burned a few holes before I got it dialed in. I will likely go to oxy/acetylene for the rest. Its much easier to keep from burning through with that.


Baby Beast 2- 1999 4Runner SR5

Baby Beast -1987 4Runner SR5-Gone, but not forgotten

Generation Dead
Reply With Quote