View Single Post
  #4  
Old 09-16-2005, 05:13 PM
Rzeppa's Avatar
Rzeppa Rzeppa is offline
Cruise Moab Committee
 
Join Date: Aug 2005
Location: Kittredge CO, USA
Posts: 5,256
Default

Robbie is correct, the 5 speed that will fit a 1FZ is the H151. The 1HZ diesel will bolt to the H55F however. And as Robbie points out, the best source for the bits needed for a combo such as this would be a dismantler in Oz. Personally, if I were going to go through the brain damage of such a swap into a 40, I would go for a diesel such as the 1HZ/H55F such as Dave Tay did, or better yet, the newer 12HD-T with H151, with approximately the same dimensions but much higher performance. Both of the latter combos are available from Japan through Greg Bowie and Steve Walsh in BC:

http://www.gscruiserparts.com/aboutus.html
__________________
Jeff Zepp
Kittredge CO USA
1971 & 1976 FJ40s, 1978 FJ45, 1987 FJ60
Rising Sun 4WD Club, TLCA #4063
http://american3dprinting.net/
Reply With Quote