Thread: Engine Work?
View Single Post
Old 07-06-2010, 12:02 PM
MattFJ40 MattFJ40 is offline
Rock Stacker
Join Date: Jun 2010
Location: Colorado
Posts: 12

There is a fair amount of residue on the block from the old head gasket. Seems the fel-pro gasket is made of some material that basically melts (or seems that way). I purchased some foam gasket remover from an auto store and tried to scrape it off with a razor with little success. I was hunched over the block so long my back went out again. Does anyone have any thoughts on how to get off tough residue on the block from the gasket?
Reply With Quote