View Single Post
Old 08-17-2010, 04:55 PM
PhatFJ's Avatar
PhatFJ PhatFJ is offline
Rising Sun Member
Join Date: Apr 2008
Location: Trinidad, CO
Posts: 647
Default Drive shaft work for my 40

Hi all, I just picked up a 1993 350ci with TBI injection that I am going to drop into the 40 in lieu of the existing 327. At the same time, I am going to get things set up right in the engine compartment and re-locate the motor and mounts. With this said, I will be needing the drive shafts reworked. Any thoughts on where I should take them, or should I consider replacing these (I think stock) shafts with new ones to handle the increased power and torque? Thanks in advance for the advice!!!!

1975 FJ40 Restored, (sold) back to Japan
1972 FJ40 project X2
1989 FJ62
1985 FJ60
1970 FJ40 - trail rig ARB's front and back.
1995 4Runner MB Diesel conv.
2000 4runner
2007 FJC BUILT (Sold)
2004 GX470 Way Bad, Lifted and moded just right...

Trinidad, CO
Reply With Quote