View Single Post
  #15  
Old 08-18-2010, 02:06 PM
maxsdad maxsdad is offline
Lifted
 
Join Date: Nov 2006
Location: Highlands Ranch
Posts: 189
Default

My turn to say sorry...been ultra busy...
The sensor in the distributor is the cam position sensor. We did look at it and clean it up a bit, but have not tried to replace it..I think there's a multi meter test you can use to determine whether it's working correctly or not - we'll look into it.
Checked all the vacuum lines - they are fine.
Thanks to your friend for his advice.
Quote:
Originally Posted by RedCreeper View Post
Sorry for the time it took to get back with you. My buddy suggested cap, rotor and timing chain. this was before he knew about the mapp sensor. He also mentioned there might be a sensor in the ditribitor that might be acting up. When i told him about the mapp sensor issue he said to check the vacum lines for blockage or leaks.
Reply With Quote