View Single Post
  #4  
Old 08-20-2010, 10:20 AM
Haku's Avatar
Haku Haku is offline
Wincher
 
Join Date: Mar 2010
Location: Denver (Highlands aka NW Denver), CO
Posts: 82
Send a message via AIM to Haku
Default

I already have the axle torn down and the thing pulled apart. I know I can do the "slam it on the ground" thing, but I prefer to do it "the right way" and use a press. By jig I mean someone who cut down a dead axle housing that you bolt the axle assembly to and press it out with a shop press. Here is what I am talking about....the jig being the custom made "special service tool"....

http://www.4x4wire.com/toyota/mainte...wheel_bearing/

I have my daily driver, so I can bring the axle shaft/wheel bearing assembly part to whoever has this stuff.

Josh
Reply With Quote