View Single Post
  #688  
Old 12-29-2010, 07:12 AM
treerootCO's Avatar
treerootCO treerootCO is online now
Rising Sun Member
 
Join Date: Aug 2005
Posts: 4,503
Send a message via AIM to treerootCO
Default

Quote:
Originally Posted by coax View Post
What kind of welder did you use to do the work? I've got a low-speed cluck that I am pretty sure is the rear panhard. Hoping its just the bushing and no welding necessary, but I really don't feel like digging into it while its cold out. Nice job!
It is a Miller 175, 220volt, wire feed mig. Must have left the tank on because the shielding gas was all gone. That always makes overhead welding fun with solid wire. I was able to get the drill in from the back to redrill the holes. You couldn't tell by looking at the hole either but the bolt had about an 1/8 inch play in all directions front and back.
__________________
aka Mike D.----->Bio Page KDřGWY
“He who goes unarmed in paradise had better be sure that that is where he is.”—James Thurber
"Its better to be thought a fool rather than to speak up and remove all doubt." - Lincoln
pride is ego, the word I had lost was dignity. The quality or state of being worthy of esteem or respect.
Ptarmigan build thread - 95FZJ80
www.root45.com
www.risingsun4x4club.org

TLCA #14133

Reply With Quote