View Single Post
Old 05-24-2011, 09:32 AM
DaveInDenver's Avatar
DaveInDenver DaveInDenver is offline
Hard Core 4+
Join Date: Jun 2006
Location: Larimer County
Posts: 6,614

Not sure if it would work with your outlet, but you see the little hole in the middle of the assembled PowerPole? You are supposed to put a tiny roll pin in there to keep the two parts from sliding back.

But if you leave out the roll pin you can thread a small ziptie or a twisted piece of wire through both holes of the mated connector, which keeps them from vibrating apart.
'91 Toyota Pickup
'09 Kawasaki KLR650
'12 Gunnar Rockhound 29

"To live is to suffer, to survive is to find some meaning in the suffering." -- Friedrich Nietzsche
Reply With Quote