View Single Post
  #8  
Old 10-04-2006, 11:08 AM
FJBen's Avatar
FJBen FJBen is offline
Hard Core 4+
 
Join Date: Aug 2005
Posts: 893
Default

Quote:
Originally Posted by Nay
Very nice - are you planning on 12" Bilsteins up front as well? Or 12" rear and 10" front? Any issues dropping the coils too far off the tower?

Nay
My 14" Bilsteins came in today for the rear and the front I'll be running 12" Steins, I don't see any issues with the front unseating, the rear will be a problem. So I will retain those so I get some negative pull from it.

I know the rear will still pull out as the extended length is 35" on those 14" shocks...Worst case I will probably loose 1/2"~3.4" on compression s these bilsteins have a longer collapsed length than the Pro-comps that were on there.

I don't have any pics of the pieces not installed... But I may pull them out again to document it better. They basically look just like that 3d pic.

i'm wondering if I'm going to have any panhard issues with that much flex. I'm getting the parts to adjust them with this next week. I'll make a mount on the axle for the rear and the front I'm a bit baffelled.

Any reason to NOT thread that front solid rod??? and run a coupler setup? otherwise I'll just sleeve and then add inserts and go that route.
__________________
TLCA#15530

96 285's OME 's ride
Reply With Quote