Thread: Top end rebuild
View Single Post
  #1  
Old 03-08-2012, 08:50 PM
farnhamstj's Avatar
farnhamstj farnhamstj is offline
Hard Core 4+
 
Join Date: Aug 2005
Location: vail co
Posts: 2,583
Default Top end rebuild

Time to tech up this section of the forum with some graphic photos of my work in progress. Purpose of the tear down is to get is ready for the upcoming season. I've replaced the piston and cylinder on the PW-80. Never tackled a 4stroke before. Purchased a timing chain tool and went at it today. Also disassembled the Reklus clutch. I'm about 4 hours into the project. Piston had some carbon I cleared off, cylinder looks perfect to me. The valves/seats look good to me an still have adjustment left in tappets, but I'm sending it out anyway unless someone thinks I'm wasting money. Any feedback welcome.
Attached Images
 
__________________
98 uzj100. Factory rear-ARB front locked 4.88's. ARB Bull, Warn 9000, Irbis rear bumper, Slee sliders and belly pan. OME t-bars w/863 rears, HID, XM
KD0GWO
Reply With Quote