View Single Post
  #5  
Old 10-29-2012, 08:02 PM
Rzeppa's Avatar
Rzeppa Rzeppa is offline
Cruise Moab Committee
 
Join Date: Aug 2005
Location: Kittredge CO, USA
Posts: 4,946
Default

I got all the welds ground down flush, but was still trying to figure out what to do with the fender lip on the right. I decided that I needed to add a new strip of metal there, and cut the edge smoothly.

Speaking of new strips of metal, not shown, I added a strip to the back of the lip at the bottom for the welds through the holes where I had drilled out the old spot welds.
Attached Images
 
__________________
Jeff Zepp
Kittredge CO USA
1971 & 1976 FJ40s, 1978 FJ45, 1987 FJ60
Rising Sun 4WD Club, TLCA #4063
http://american3dprinting.net/
Reply With Quote