View Single Post
  #18  
Old 10-30-2012, 05:53 PM
Rzeppa's Avatar
Rzeppa Rzeppa is offline
Cruise Moab Committee
 
Join Date: Aug 2005
Location: Kittredge CO, USA
Posts: 5,197
Default

Quote:
Originally Posted by DaveInDenver View Post
So they opted not to cut any metal out but tacked on a whole bunch of studs that threaded into a slide hammer, which they used to do the reshaping.
I thought about how to do this repair - a lot. Among the thoughts I had was to do the slide hammer thing (I have one). Another was to drill a hole (or holes) in the backside to try to pound it out from the back side. But at the end of the day, due to the crinkling of the inner fender part, I decided to do the cut out the whole section approach.

I am an amateur and still learning as I go...

__________________
Jeff Zepp
Kittredge CO USA
1971 & 1976 FJ40s, 1978 FJ45, 1987 FJ60
Rising Sun 4WD Club, TLCA #4063
http://american3dprinting.net/
Reply With Quote