View Single Post
  #22  
Old 12-05-2012, 06:21 PM
Rzeppa's Avatar
Rzeppa Rzeppa is offline
Cruise Moab Committee
 
Join Date: Aug 2005
Location: Kittredge CO, USA
Posts: 5,220
Default

Quote:
Originally Posted by kurtnkegger View Post
Thanks Jeff. I measured, double checked, and rechecked to make sure the spacing from the thrust washers was within the specs on the install sheet. I put it in about two years ago, and re-used the thrust washers that were in there already because the spacing worked. Do you suggest I open her back up and take another look? I only get noise at tight turns on pavement with the clutch depressed.
No, if you were withing spec, chances are you are good to go. And what I was referring to in my above post about how you finesse the throttle applies to what you wrote about tight turns with the clutch in. You will discover that if you are in a parking lot, you will need to apply just a slight amount of throttle when making those tight turns, believe it or not. That quiets things right down!
__________________
Jeff Zepp
Kittredge CO USA
1971 & 1976 FJ40s, 1978 FJ45, 1987 FJ60
Rising Sun 4WD Club, TLCA #4063
http://american3dprinting.net/
Reply With Quote