View Single Post
  #16  
Old 12-13-2012, 04:57 PM
azcromntic azcromntic is offline
Lifted
 
Join Date: Oct 2010
Location: Colorado Springs
Posts: 129
Default

x4 on the puller thingy. When I didn't have the puller I just used a bigger hammer on the side of it combined with some penetrating fluid.

A bigger hammer and brass drift work well on CV axles as well instead of putting on the puller. put the drift right on the center of the axle. Don't hit too hard but a couple solid hits will loosen it enough it can be taken off by hand.
__________________
KDØSFT
Reply With Quote