Originally Posted by Air Randy
I stood the cylinder vertically in the vise and then filled it with more oil using the top hole. This should have gotten it as full of oil as possible on both sides of the internal cylinder piston..
When you did the above, was the shaft fully compressed?
KA7TLT - TLCA 13015
"78" FJ-40 - "Marmot" F&R ARB Lockers, OME Suspension, MAF Shackle Rev Kit, 4+ Flip Kit, Rear Disc Brakes, Warn Winch, Safari Snorkel, 4+ Rear bumper/Tire Carrier
"95" FZJ-80 - "White Top" F&R ARB Lockers, Slee F&R Bumper & Sliders, Warn Winch, 35s, Safari Snorkel, Low Range Gears, P/T Kit
"13" Taco 4X4 Extra Cab, Firestone Air Ride, Airstream tow vehicle - "Daily Driver"