View Single Post
  #64  
Old 04-25-2013, 08:28 AM
simps80's Avatar
simps80 simps80 is online now
Rising Sun Member
 
Join Date: Jan 2009
Location: Arvada, CO
Posts: 840
Default

Quote:
Originally Posted by Air Randy View Post
The valve head could have detached from the stem too. For me, if I have an engine on the stand, I'm going to at least disassemble the bottom end and check everything out. You had enough rust in that motor I would check the rod and main bearing journals and drop in new bearings, they're cheap. Replace the rear main seal at the same time. Check the oil pump to make sure the clearances are good and there is no rust or chunks in it. Check the play and thrust on the timing gears, etc. Super easy to do at this stage. Its not much more of a step to pop the pistons, hone the cylinders and put in new rings too. For very little money you then have a known good motor versus just hoping everything is OK.

Dont assume just because it turns over easy that everything is OK, who knows why it was pulled out originally?
noted, thanks for that.

the guy pulled it to put a v8 in he said. but he also said that was the mid 80s so I think you're right, its probably best to take the next step.
__________________
Mike | KØSMP |
1997 fzj80 1976 FJ40 | TLCA # 20038
Reply With Quote