Yaesu FT-2800M kicking my butt...
So, I installed my Yaesu FT-2800M in to my 40 this weekend. Ran the cable, and installed the connector for the radio alright (after the second try)...When I try to scan for any transmission, I'm not receiving any signals really.
I did get one CW signal, and one guy talking about a Conoco station, but that was it...nothing...
I've tried searching for a solution of what I'm doing wrong, but can't find anything.
Too bad this radio doesn't have a NOOB function to just plug and play.
Any suggestions where to start?