View Single Post
  #115  
Old 09-03-2013, 10:21 AM
nakman's Avatar
nakman nakman is offline
Rising Sun Commander
 
Join Date: Aug 2005
Location: north side
Posts: 10,026
Default

Quote:
Originally Posted by nakman View Post
...eventually will make a carrier for the rear bumper.
Got around to making my carrier. Also the first official 80 series parts have made it... the pulley came all the way from northern CA for the privilege here (thanks again BrentBA!)

Started with a piece of angle, chopped it up and 6 sticks later had it zapped to the frame.. Added in a couple tie plates for good measure, but at least half those welds have decent penetration so am not too worried about it. I also cut the long side a little long, needed a MSFH to get it in position, so that interference fit makes the welds almost cosmetic. The short one is on the back bumper so will be easy to monitor.
Attached Images
      
__________________
99 uzj100, 05 525EXC

www.gamiviti.com

Reply With Quote