Calling electrical gurus.
Rear wiper operates on intermittent even when switch is turned off.
I checked the switch and didn't have continuity between pins 1,2,10, and 16 when switch was off.
So is it the relay or the wiper motor? Or should I check the switch again?
See attached pdf...
The relay side of the L-R wire is getting 12V when the wiper motor is disconnected. I think it's supposed to be 0? So if that's true that points to the relay.
Pins 1 and 4 of the wiper motor have continuity, about 20 ohms resistance. I think they are not supposed to have continuity at rest, so if that's true that points to the wiper motor.
Or maybe I'm reading something wrong?
"Stay the Trail," "Tread Lightly," and "Leave No Trace" ethics
Rising Sun Bio
2F "Brahma" + Lockright, tach, Warn 8274, FJ60 Power Steering,
soon to lose the Sanden OBA
to go back to factory emissions
1FZ-FE factory lockers + Safari Turbo
, CDL switch, cup holder, AATLAS1X leather, heated seats and JDM switches
Limited TRD 2UZ-FE SOLD