Thread: Plasma Cutter
View Single Post
Old 10-28-2013, 12:57 PM
Hulk's Avatar
Hulk Hulk is offline
Join Date: Aug 2005
Location: South Side!
Posts: 12,386
Send a message via AIM to Hulk

Originally Posted by rover67 View Post
i know this sounds like a pain... BUT you *might* get away with making a hole with a hole saw and a hand drill. how big are the holes? 4"
Originally Posted by Rzeppa View Post
X2 on the sentiment about cutting cleaner with a saw (hole and sawzall) than a plasma cutter.
Originally Posted by AxleIke View Post
Matt, I also have a lot of hole saw sizes, and a jig saw that works awesome in metal, which you are welcome to borrow at any time.
Guys, thanks for this advice -- it was just what I needed. I bought 2 1/8 bi-metal hole saws and got the holes cut. I also borrowed a friend's Bosch jigsaw (way better than my old Craftsman jigsaw) and got some appropriate blades. Result: the tail lights are now installed and recessed into my trailer bumper.
Matt Farr, Centennial, Colorado | Rising Sun Webmaster
1996 FZJ80 TLCA #4189 WRDY my Rising Sun bio Facebook Twitter LinkedIn Need satellite Internet? Check out: Exede Internet

Originally Posted by nakman
the club voted to not tell Matt Farr what happened at the meeting.
Reply With Quote