View Single Post
Old 12-05-2013, 11:12 AM
akingf5371's Avatar
akingf5371 akingf5371 is offline
Rising Sun Member
Join Date: Aug 2011
Location: Denver, Co
Posts: 439

Originally Posted by DaveInDenver View Post
Search the forum, there has been at least one thread about this.

You do need a permit in Denver for this.
You know, I didn't even think about searching for the solution. Thanks Dave!

Originally Posted by Jacket View Post
There should be a couple of existing threads on this topic - here's one:

I added a new circuit to my garage for my welder, and it wasn't much trouble at all. If you can determine the max amp draw for your welder and ensure that you have space on your panel for a new breaker, then the rest is just running wire.

Tip #1: Make sure you shut off the main breaker on the house panel before you attempt to install a new circuit
Thanks Jacket! I hope it's not too tough. Still would like to bounce ideas of someone in person.

Originally Posted by subzali View Post
Tip #2 if your house is like mine it won't have a main breaker on the house panel so then you're screwed...

Adam Farmer

2010 4Runner Trail 3" Lift, UCAs, and 285 Goodyear Duratracs

1982 FJ40 Green 4" HFS Lift Resto Thread - (Mid - Resto)

email: akfarmerslb at
Reply With Quote